找诗词>英语词典>grind on翻译和用法

grind on

英 [ɡraɪnd ɒn]

美 [ɡraɪnd ɑːn]

令人厌烦地继续下去

柯林斯词典

  • PHRASAL VERB 令人厌烦地继续下去
    If you say that somethinggrinds on, you disapprove of the fact that it continues to happen in the same way for a long time.
    1. Civil war in the Sudan has been grinding on for nine years.
      苏丹内战已经持续了9年之久。

双语例句

  • Mortierella mycelium oil extractions by different pre-treatments ( moisture content, grind method, grind degree) under supercritical condition were studied The relation between grind degree, grind method and moisture content on oil extraction has been obtained
    研究了不同预处理(水分、粉碎粒度)的被孢霉菌丝体在二氧化碳超临界流体条件下的油脂萃取,确定了粉碎粒度、水分与油脂萃取之间的关系
  • There isn't room for much more waste, and yet the factories grind on.
    再没有地方来放置更多的垃圾,然而工厂却仍在拼命生产。
  • I always rehydrated, rested, and refueled before the afternoon run, so I had a much better chance of hitting a quality pace than if I'd tried to grind out those same miles on the end of one long run.
    在下午跑之前,我总是补水,休息,吃东西,因此,与以前一次性跑同样的距离相比,我更有机会达到高品质配速。
  • A Grind Manufacturing System Based on Fuzzy B-Spline Neural Network Control
    一种基于模糊B样条基函数神经网络控制的磨削加工系统
  • Grind the threaded bush bright on the contact surface with the seat cross member.
    打磨座椅横梁接触面上的螺纹衬套。
  • There's a few exceptions, but most things you can really grind on and certainly that was kind of the history of Microsoft in the early days.
    有一些例外,但是大多数都是耗时长久,早期微软也是如此。
  • Because the superalloy is difficult to grind and on the surface of grinding wheel there exists serious adhesive substance, the grinding force and temperature will increase remarkably, and the grinding ratio is very low.
    由于高温合金的难磨性以及磨削时砂轮表面存在严重的粘附物,因而使磨削力和磨削温度显著增高,磨削比非常低。
  • Grind the trophoblast wire on the mesh 200 to get cells suspension.
    并取子宫滋养层,用200目钢丝筛网,进行研磨,获得单个细胞悬液。
  • It'll be a real grind to go on the bus.
    乘坐公共汽车真是一件令人苦恼的事。
  • The article describes in detail how to determine process method, process plan, and how to grind the P root on creep grinder.
    本文详细介绍了P型叶根加工的工艺方法、工艺方案的选定以及如何在强力磨床上实现P型叶根的磨削加工。